QA

How To Change The Furnace Filter

Do you have to turn off furnace to change filter?

1. To Change Your Home Air Filter, You’ll Need To Turn Off Your Furnace. To prevent the HVAC unit from turning on while you are changing the filter, make sure you turn the thermostat to the “off” position. For maximum safety, disconnect power from your furnace system while you are doing maintenance.

What happens if you put a furnace filter in backwards?

When a furnace filter is placed backwards, the fibers can’t do their job properly. This means your furnace has to work harder to generate the same air flow, resulting in increased energy costs. Particles are also allowed to build up irregularly, making the furnace working even harder to draw air.

How often should you change furnace filter?

In general, this is how often changing furnace filters needs to be done: For 1- to 2-inch filters, replace them every 1 to 3 months. For 3- to 4-inch filters, replace them every 6 to 9 months. For 5- to 6-inch filters, replace them every 9 to 12 months.

What happens if you don’t clean your furnace filter?

Short Cycling. If the air filter is not serviced often enough, it will eventually become clogged to the point that air cannot pass through it. When the furnace is operating, the lack of air flow will trap the heat in the system. Without a new air filter, the furnace will overheat every time it starts up again.

Where is furnace filter located?

The furnace filter is usually located inside of the blower compartment, where the return air enters the blower compartment. Most units have built-in furnace racks. The large metal furnace compartment contains a filter and blower.

How do I know which way the air flows in my furnace?

If you are looking at a furnace filter, find the arrow that indicates the proper air flow direction. That arrow must always face toward the furnace and away from the return duct that carries the air in need of heating or cooling.

Which way do I put my air filter in?

Slide the new filter in with the arrow pointing toward the furnace. Replacing your air filter is not difficult. Remember that air flows from your ducts, through the filter, and into the furnace. The arrow on the filter should always point toward the furnace.

Which side of furnace filter should be dirty?

In all cases, the furnace filter should be dirty on the side that the air comes into the furnace from. If your air filters are dirty in some other fashion, it is likely your furnace is not working properly, or the filter was installed incorrectly.

How much is a furnace filter?

Although flat filter designs offer the most savings upfront, they need to be replaced more frequently and may cost you more in the long run. Replacing these filters can cost anywhere from $40 to $200 a year.

Why are my air filters so dirty?

Ducts that have holes, gaps, or leaks should be sealed up properly to prevent good air from getting out and bad air from getting in. If there is a leak in the return air ducts, the dusty, dirty air from spaces like that attic or crawl space gets sucked up into the ducts, dirtying the air filter and causing clogging.

Why does my house get so dusty?

Dust accumulation in your home is a product of airflow, either because too much dirty, dust-filled air is floating around your home or because not enough air is spreading through the home, allowing dust to settle.

Can you vacuum and reuse furnace filters?

Some air filters — permanent and semipermanent models — can be cleaned as part of regular HVAC system maintenance and replaced for continuous use. At regular intervals, you must remove it from the HVAC cabinet, throw it away, and install a fresh filter. Disposable air filters shouldn’t be vacuumed or moistened.

Is no air filter better than a dirty one?

Running your air conditioner without a filter is worse than running it with a dirty one. Instead, get to the store as soon as possible for a replacement or call an HVAC professional for replacement. Without a filter, your air conditioner is at risk for severe and expensive problems.

Why is my heat blowing cold air?

A clogged filter is one of the leading reasons for a heater blowing cold air. But even if you swap the air filter with a brand new one, dirt and debris can still be found within the unit. This could eventually lead to overheating. If your furnace looks pretty dirty, call an HVAC provider for a professional clean.

How many filters are in a furnace?

Most furnaces will have a V shape filter system; the system will take 2 filters. The filters go up into the plenum in a V shape. Make sure that when you re-install the top door, it goes over the furnace frame so it engages the safety switch.

Do all houses have air filters?

The air filter is typically located at the point where the return duct enters the air handler. Larger houses often have more than one HVAC system. Each system will typically have at least one air filter. Therefore, your home may have air filters located at the air handler AND in the returns.