Table of Contents
It is very inexpensive to replace a serpentine belt whether it’s broken or loose. The replacement cost is only going to be between $100 and $200 in most cases. The belt itself will cost between $25 and $80 while the labor costs will probably be between $75 and $120.
How much does it cost to replace a pulley?
It will cost between $125 and $380 to have your pulley replaced. The labor should cost between $45 and $155 and the parts should cost between $85 and $225.
How much does it cost to replace a serpentine pulley?
A typical serpentine belt generally starts at around $15 and goes up to $80 at most. Add to that the labor costs that can range from $75 and $120. Altogether, you’re looking at around $90 to $200 (plus taxes and fees) to replace your serpentine belt.
How much does it cost to replace a belt and pulley?
The average cost for a drive belt tensioner replacement is between $211 and $239. Labor costs are between $73 and $93, while parts are priced between $138 and $146.
How much does it cost to replace an idler pulley and belt?
There is an average cost for a drive belt idler pulley replacement. Labor costs are between 64 and $81 while parts are between $79 and $83.
How long does it take to replace a pulley?
If you are doing the job at home, give yourself about four hours to change all the parts. You will need the following tools and parts: Replacement idler pulley. Tensioner pulley.
How much is it to change a belt?
Of course, it depends on your make and model as well as labor costs, but in general a replacement serpentine belt costs around $70-$200 (plus taxes and fees), including around $50 for the belt and around $150 for the labor.
How long does it take to replace a tensioner pulley?
What Is Tensioner Pulley Replacement? Replacing the pulley should only take an hour or two, and the parts will vary in cost from one type of car to the next.
Can an alternator pulley be replaced?
In many cases it is possible to remove and install the overrunning alternator pulley while the alternator is still on the engine. The plastic protective cap cannot be re-used after it has been removed from the pulley. A replacement cap is supplied with the new part.
How much does it cost to replace a water pump pulley?
Water Pump Pulley Replacement pricing for various cars Cars Estimate Average Dealer Price 2009 Honda Element $413 $456.79 2008 Toyota Camry $165 $177.69 2008 Ford Edge $291 $308.48 2008 Cadillac DTS $193 $210.54.
Can you replace a belt tensioner yourself?
Serpentine belt replacement is easy because today’s automatic drive belt tensioners eliminate the need to loosen bolts or pry components into position for retensioning. Just rotate the tensioner, remove the old belt and install a new one.
When should you replace an engine pulley?
An idler pulley is expected to wear over time, and eventually the pulley will fail. Replacement intervals for idler pulleys vary, but are usually within the 50,000 to 100,000 mile range. Replacement often coincides with expected serpentine/accessory belt replacement periods.
How can you tell if your belt tensioner is bad?
One of the most common symptom of a bad or failing drive belt tensioner is noise from the belts or tensioner. If the tensioner is loose the belts may squeak or squeal, especially when the engine is first started.
Can you replace the pulley on a belt tensioner?
More often than not, just the pulley goes bad on the tensioner, not the whole tensioner, and for most vehicles, you can purchase and replace the pulley instead of the tensioner itself. The pulley should be replaced if it has a lot of resistance when you spin it.
Is the idler pulley and tensioner pulley the same?
Idlers vs. The primary distinction between tensioners and idler pulleys is the presence of an adjustable bolt. Tensioners are positioned on the bolt through mounting. Idler pulleys are not mounted to an adjustable bolt. However, if bearings fail, tensioner and idler pulleys both require replacement.
How do I know if my alternator decoupler pulley is bad?
Look for signs of grease around the pulley indicating a bad seal. If you can get a view inside the alternator, the rotor should continue to spin down when you shut off the engine. If the charging system warning indicator is on, the OAD may be the culprit, not necessarily the alternator.
How long does it take to change a water pump pulley?
Changing a timing belt and water pump can take anywhere from 1-3 hours depending on your skill level, so make sure you have the time and space to complete the job. Do the following before you start: Jack up the front of the car so you can access the undercarriage beneath the engine.
What is the average cost of a water pump replacement for a car?
The average water pump replacement cost is $550, with prices ranging from $461 to $638 in the US in 2020. But typically depends on the type of vehicle you drive and the auto repair shop you take it to. Labor costs are between $256 and $324 while parts cost between $205 and $314. Estimate doesn’t include fees and taxes.
What causes a water pump pulley to break?
Physical damage to the water pump pulley There are multiple ways this metal component can be damaged, including having an incorrect sized or improperly adjusted water pump belt installed, vehicle accidents or problems with the internal bearings that allow the pulley to spin.