Table of Contents
Draw weight is a measurement of the force required to draw a bow. Bows with higher draw weights generate faster arrow speeds by transferring more energy to the arrow. The result is a flatter trajectory, deeper penetration, and greater likelihood of pass-through shots when bowhunting.
Is 70 lb draw too much?
For example, a bow with a 70-pound peak weight and a 80% let-off should have a holding weight of around 14-pounds. Being able to hold a bow at full draw for 30 seconds is great, but if you’re shaking, struggling, and exhausted at the end of that time, then you’re not going to be able to make an ethical shot.
How does draw weight affect arrow spine?
Bows with high draw weights need arrows with stiffer spines. As draw weights decrease, so must the arrow’s stiffness. In addition, short arrows are less flexible than long arrows, and heavier points need shafts with stiffer spines than do lighter points. You’ll find the spine number on the arrow’s label.
Does higher draw weight affect accuracy?
Arrow accuracy can be effected if the draw weight is increased as an arrow’s spine needs to be matched to the draw weight. If this has been done then the arrow matches the bow. A significant increase in bow draw weight will mean that the existing arrow no longer matches the bow.
Does bow draw weight affect accuracy?
Being over bowed, too heavy draw weight, will cause bad habits. Back the draw weight off and use the correct spine arrow. Read the manual to determine how many turns the limb bolts can be backed off. Speed is fine, accuracy is final.
What draw weight do most hunters use?
Some shooters are capable of shooting 70, 80 or 90lbs, but most adult males shoot between 60 and 70lbs. Today’s bows are extremely efficient and 40lb compound bows are more than capable of harvesting many big game animals. For whitetail deer hunting anything above 40 lbs is fine.
What happens if arrow spine is too stiff?
If the arrow’s spine is too weak or too stiff, the arrow will not correct itself as soon as it should while in flight. If that arrow is weak and continues to flex (has a low spine rating), it’s going to veer off target. While an arrow will necessarily twist and turn in flight, what you don’t want it to do is wobble.
How long should my arrow be for a 28 inch draw?
If you’re a 28-inch draw length and want an arrow that ends at the front of the riser, your arrow length would be around 27 inches. However, your arrow length can be longer if you need to weaken the spine of your arrow. For safety reasons, your arrows shouldn’t be cut too short.
How heavy should my arrows be?
Overall Arrow Weights I think a good average hunting arrow should fall in the 6 to 8 grains per pound of bow weight, with lighter bows maybe even closer to 9 to 10 grains per pound. A typical 60-lb. bow should be in the 360- to 480-grain range, a 70-lb. bow in the 420- to 560-grain range.
How does draw weight affect arrow speed?
Draw weight is a measurement of the force required to draw a bow. Bows with higher draw weights generate faster arrow speeds by transferring more energy to the arrow. The result is a flatter trajectory, deeper penetration, and greater likelihood of pass-through shots when bowhunting.
Do heavier bows shoot farther?
Heavier arrows will not travel as far because they will be pulled down by gravity, but they will be more accurate than lighter arrows and deliver a more penetrating impact to the target. The range of a heavier arrow will be less than that of a lighter arrow.
Are heavier bows better?
If you choose to go with an ultralight bow, just remember that heavier bows tend to hold steadier. With a light bow, it’s possible for shooting form flaws to be exaggerated. And as much as accessories, such as quivers and sights can upset the balance of any bow, that imbalance can be especially apparent on light bows.
Does changing draw weight change sights?
Yes,you’ll need to adjust your peep when you adjust the draw weight. Going from 45 to 60 will change every spec on your bow and will also twist your string.
Does draw weight affect draw length?
The draw weight is marked on the bow’s lower limb with the pound sign (#),such as 35# @ 28”. That translates to 35 pounds of draw weight at a 28-inch draw length. A compound with a 50-pound draw weight at 28 inches will remain at 50 pounds if it’s adjusted to a 26-inch draw length.
Are bows heavy?
It’s difficult to generalise, but the recurve men at the 2018 Hyundai Archery World Cup Final shot an average bow weight of around 48-50 pounds. That’s about the same weight as the luggage most people check in at the airport. A qualification round will involve an archer pulling a total weight of well over two tons.
How hard is it to pull back a 40 pound bow?
The draw weight is basically, “How strong do I need to be in order to pull this thing back?” For a recurve bow, it’s measured by pulling back to 28 inches. So for a 40 lb bow, it means that it takes 40 lbs of force to pull back the string 28 inches for a recurve.
How far can a 20 lb bow shoot?
Even out to about 20 yards, with a broadhead, yup. If you were good, 30-40 yards most likely. Those arrows don’t slow down as much as you think. Recurve bows are a different beast (think Arrow), but compound bows are very fast and thus there’s a lot of energy behind that arrow.
Is 50 lb draw weight enough?
As a rule of thumb, 40 pounds of kinetic energy efficiently kills whitetails, and 50 pounds or greater is required for larger game such as elk, moose or bear.
