Table of Contents
Source and drain lines come through the floor. In a typical clawfoot tub installation, both the water source pipes and the drain pipe enter the bathroom through the floor.
How do freestanding baths drain?
The process of plumbing a freestanding bath works the same way as regular bath tub being plumbed, with a waste in the front leading to the drain pipe adjacent to the hot and cold water pipes that stop at your tub, or continue up to your shower.
Why are clawfoot tubs bad?
“It doesn’t butt up against the wall, so you get a lot of spillage and it can cause damage to your wall or can seep in and actually drip down from your bathroom to your lower level ceiling,” Jonathan Scott of HGTV’s Property Brothers, told PopSugar. Consider tiling bathroom walls or nixing a clawfoot tub altogether.
How do soaking tubs drain?
Bathtub drains have two legs, one to the main drain opening and the other to the overflow drain opening. With a pop-up drain, linkage forces the drain stopper up or down by way of a rocker arm. With the plunger type, a hollow brass plunger slides up and down inside the drain assembly to seal the drain opening.
Does a clawfoot tub need an overflow?
Some bathtubs, such as freestanding or clawfoot tubs, look better without an overflow drain. You can install a floor drain instead, so that any overflow gets drained away properly, instead of damaging your floors and potentially ceilings.
Where does the water drain in a clawfoot tub?
Source and drain lines come through the floor. In a typical clawfoot tub installation, both the water source pipes and the drain pipe enter the bathroom through the floor.
How far should a clawfoot tub be from the wall?
The distance between your tub and wall should be between 15-18 inches or at least 1 foot.
Does a clawfoot tub add value to a home?
According to the RealEstate.com survey, starter homes with claw-foot tubs sold for nearly 30% more than expected. Coffered ceilings also helped homes sell for 30% more than expected, and farmhouse sinks (thanks Joanna Gaines) helped homes sell for 26% more than expected.
What do the numbers on the bottom of a cast iron tub mean?
The cast iron is exposed on the outside and bottom of the tub, and although it may have been painted, the manufacturer’s stamp — if there is one — is often clearly visible. This number states the length of the tub in feet. Possibilities include 4, 4 1/2, 5, 5 1/2 and 6.
Are all bathtub drains in the same spot?
All bathtubs drain in basically the same way, with a drain assembly located on the bottom of the tub linked to an overflow that may or may not have a toggle switch. When the plunger or stopper is opened, water drains out of the bathtub, through the drain assembly, down a tailpiece and into the trap.
Do they make center drain bathtubs?
These tubs are available In “Center Drain” configuration only. In addition these tubs are backed up with a 5 year manufactures warranty.
Is my tub left or right drain?
The easiest way to figure out which kind of tub you’ll need is to stand in front of your shower as if you are going to go into it. If the drain is to your right you have a right handed tub, and if the drain is on your left you have a left handed tub.
Where does bathtub overflow drain go?
The main drain is usually located at the bottom of your bathtub. The overflow component is located several inches under the rim. The two drains connect to various tubes that run from the bathtub and ultimately merge into one central pipe.
Does a free standing tub need a vent?
You need a vent before it goes vertical after the trap and can t use 2 traps.
What does tub overflow do?
The overflow drain on a bathtub prevents a bathroom flood by passively draining water once it reaches a certain level in the tub. The overflow drain pipe connects to the main tub drain pipe to dispose of the extra water.
How many gallons does a cast iron tub hold?
Alcove cast iron bathtubs are usually 60 inches long, hold 32 gallons of water, and weigh 320 pounds on average. Freestanding cast iron bathtubs are 60 to 75 inches long, hold up to 82 gallons of water, and weigh an average of 385 pounds; however, large ones can weigh up to 500 pounds.
How do you remove a cast iron tub drain?
How to Remove a Cast Iron Tub Directions Shut off the water supply to the tub. Open tub faucet to drain water remaining in supply lines. Remove screws securing the plate covering the overflow assembly. Work loose the lever hook and take it out. Take out the drain stopper.
How do you remove a clawfoot tub drain?
Follow these steps to replace and old, rusty clawfoot tub drain. Step 1 – Shut Off the Main Water Supply. Step 2 – Disconnect the Tub From the Water Supply. Step 3 – Remove the Overflow Plate. Step 4 – Removing the Overflow Pipe. Step 6 – Taking Away the Old Putty. Step 7- Installing the New Piping.
Will a clawfoot tub crack tile?
Will a clawfoot tub crack tile? Tile floors, especially porcelain, are very durable and will not break under heavy weight but they can scratch. Tile flooring is ideal for supporting a heavy bathtub at full capacity.
Can I put a clawfoot tub on tile?
You are fine installing a claw-foot iron tub on porcelain tile as long as you place the tub carefully. If you drag the tub across the tile you run the risk of scratching the porcelain if it’s a lower quality.
Are freestanding tubs going out of style?
The freestanding bathtub is a current bathroom remodeling trend that may soon be going out of style. Freestanding bathtubs are also very heavy and may require a reinforced floor. Doorless showers. A doorless shower may increase the amount of floor space in your bathroom, but it also creates a problem with humidity.
Can you scrap a cast iron tub?
If you have a cast iron sink or tub, it may very well be worth scrapping, especially if you can’t find some way of selling it to someone else. While you can find ways to repurpose a cast iron sink or tub, you may also need to get rid of it from your home.
Can a freestanding tub go against a wall?
While it’s not necessary to tile around a freestanding tub, if the freestanding tub is against a wall, you’ll need to protect the wall from water damage. Tile is not the only option. Alternatives include wainscot, glass brick, and mildew-resistant paint. Wainscoting on wall behind freestanding tub.
