QA

Question: How Long Should Hay Dry Before Baling

As a rule of thumb, wait to rake hay until after the dew has dried and the sun nears its peak, around 11 a.m. If possible, let the raked hay sit for an hour or two before baling to allow more drying time.

How long after you cut hay can you bale?

Subject: RE: How long does your hay lay to bale dry? Cut first thing in the morning, ted about 2-4 hours later, do nothing the next day, rake as soon as dew is off (-48 hours after cutting), let dry about 3 hours, and bale. Sometime takes an extra day to dry or occasionally a day less if perfect weather.

Can you cut and bale hay the same day?

In a trial at the University of Wisconsin Arlington Research Station (Figure 2) where alfalfa was put into a wide swath it reached 65 percent moisture in about eight hours and could be harvested for haylage the same day as cutting.

Can hay be too dry to bale?

While hay with exceptionally low moisture might not be at risk of growing mold and bacteria, that’s because much of that hay’s nutritional value is already gone. When hay is too dry before baling, the leaves of the forage become stiff and brittle, making them much more likely to fall off.

How dry is too dry for hay?

When hay is baled, it should not be higher than 18 to 22 percent moisture. At higher levels of moisture, bales lose large amounts of dry matter (Figure 1) caused by excessive heating and molding (Figure 2). In severe cases, spontaneous combustion is possible.

How do you make hay dry faster?

Make A Wide Windrow Swath width is an easy adjustment that has a big impact on drying time. Lay the crop as wide as practical. Do not cut hay into a tight windrow. A wider swath will dry faster, because more drying area of the hay is exposed to sun and wind.

When should you Tedder hay?

Initial tedding should be performed after a brief wilting period following a morning cutting while the hay is still moist (two to four hours). In very damp conditions, tedding may need to be done immediately after cutting. A second pass is usually done the next day, and the hay is raked and baled that afternoon.

How many times a year can you cut hay?

In most areas of the country, grass hay can be cut twice, sometimes three times, per year. The first cutting generally has the largest yield. Some animals, like sheep, prefer the tender stems of second or third cutting hay.

How long does it take hay to dry after cutting?

Proper dry matter content for chopping haylage can often be achieved within 24 hours or less as compared with 3 to 5 days for dry hay. Proper dry matter content for silage ranges from 30 to 50% (50 to 70% moisture) depending on the structure used.

Why do farmers cut hay at night?

Though starches and simple sugars accumulate during the day, a substantial amount of these carbohydrates are used up during the night for growth and maintenance (via the processes of respiration). Therefore, cutting the crop at night will likely maximize the sugar in the crop, at least at the time of cutting.

Why do farmers leave hay bales in the field?

If they are scattered around the field the farmer is just waiting for a convenient time to pick them up and move them. If lined up along the edge of the field they are being stored there. Big round bales can handle being left outside, and even if the outside looks weathered the inside will be good for a year or longer.

Does rain hurt cut hay?

Research at Iowa State University found that fresh-cut hay with less than 1 inch of rain took a few more hours to dry, but didn’t suffer much, if any, quality or quantity loss. A light rain on nearly dry hay, though, caused significant losses.

Should hay be wrapped?

“Producers should use a hay preservative on hay in the 15-30% moisture range rather than attempt to make haylage by bagging or wrapping the bales.”Apr 23, 2014.

How many bales do you get per acre?

With an average bale weight of around 40 pounds (with our Abbriata small square baler or any of our mini round balers), that’s 100 bales to the acre for a first cutting.

When should I start cutting hay?

On average the entire process of mowing, raking and baling hay takes 3 days—in good weather. Therefore, pastures should be cut when a window of at least 3 days of sunny, dry, hot weather can be expected. Some farmers cut on the last day of a rainy spell in order to maximize the number of hours of drying time.

Will raking hay help it dry?

Raking tends to roll the wetter hay from the bottom of the swath to the outer surface of the windrow, which improves drying. Following the initial improvement, the increase in swath density can reduce drying rate, so the crop moisture content at raking is important.

How long should hay cure before feeding?

The notion of a “curing” phase is not a new one, and Crandell pinpoints its origin easily. “Some traditional horsemen believe that fresh-baled hay should ‘sweat’ for two to four weeks before feeding. This allows the hay to cure, which might be important if the hay too wet when it was baled.