Table of Contents
Each cubic yard costs about $65. However, a fully loaded cement truck will hold 10 cubic yards—and partial “short” loads cost $15 to $20 extra for every cubic yard less than a full load.
How much concrete do a concrete truck hold?
Concrete trucks weigh an average of 25,000 lbs. by themselves and up to 40,000 lbs. when carrying a full load. Their capacity is around 8 cubic yards, but can be up to 10 cubic yards if fully-loaded.
How many yards is a full load of concrete?
One full truckload of concrete is about 10 cubic yards and costs between $1,169 and $1,444 depending on the PSI mix. Anything less than a full truckload is considered a short load which adds $53 per cubic yard to your final price.
How far can a cement truck reach?
On average, the farthest distance concrete can be placed using a chute is 18 feet, measured from the truck’s tires to the point of discharge. The wheels of the ready-mix truck must be kept 1 foot away from below-grade walls and 1 foot away from excavations and trenches.
How much does it cost to pour a 24×24 slab of concrete?
A typical 24×24 garage slab costs between $3,057 and $5,944 with prices ranging from $5.31 to $8.31 per square foot for a 4” reinforced slab of concrete, and $6.83 to $10.32 per square foot for a 6” slab of reinforced concrete.
How many yards of concrete do I need for a 24×24 slab?
For example, for a concrete slab that is 24′ X 24′ X 4”, simply enter 4 in the Thickness/Depth field, 24 in the Width field, and 24 in the Length field. Click “Calculate”. Your answer should be 7.11 yards. Note: The Concrete Volume Calculator can also be used to determine yardage for aggregate products.
How much does it cost to pour a 20×30 concrete slab?
The average cost of a 20×30 concrete slab is between $2,400 and $4,800. The median price is about $3,600. However, the thickness of the slab and other features may increase or lower the cost.
Is it cheaper to mix your own concrete?
One of the least expensive ways to get concrete is to mix your own. You can buy bags of the mix from a home improvement store. Otherwise, you risk getting a weaker concrete once it cures, which could lead to cracks or crumbles within a couple of years.
How much does a concrete truck weigh with 10 yards of concrete?
If a truck is carrying 10 cubic yards, then the weight of the concrete is approximately 40,000 lb. The truck will weigh approximately 26,000 lb. for a total of 66,000 lb.
How far can a concrete truck reach without a pump?
Wider Reach The vertical reach is roughly 137 feet for a typical boom pump, and the horizontal reach is about 124 feet. But equipment may vary, so it’s best to check with the ready-mix concrete delivery company about your particular needs.
How far can a front loader concrete truck reach?
So the normal maximum total chute length is a little more than 16 feet, depending on the brand and model truck. Actually depending on the mix design and slump concrete can travel down a chute up to 40 feet before aggregate segregation becomes a problem.
How high is a concrete truck shoot?
A typical standard is 3 to 3.5metres.
How thick should a concrete driveway be?
As for thickness, non-reinforced pavement four inches thick is standard for passenger car driveways. For heavier vehicles, a thickness of five inches is recommended. To eliminate standing water, the driveway should be sloped towards the street a minimum of one percent, or 1/8 inch per foot, for proper drainage.
How much does it cost to pour a concrete slab for a basketball court?
The cost of a concrete slab costs about $7 to $8 per square foot. So, a concrete slab for a half basketball court may cost up to $18,800. After the concrete slab or other base coat is poured, you need to cover it with the actual material for the basketball court.
How much concrete do I need for a 10×10 slab?
The amount you will need for a 10 x 10 slab is 1.3 cubic yards, we always add an extra 10% to allow for any slab depth variations or spills that may occur.
How many square feet is a yard of concrete 4 inches thick?
One Cubic Yard of Concrete: 4-inches thick – covers 81 square feet.
How thick should a concrete slab be?
Standard concrete floor slab thickness in residential construction is 4 inches. Five to six inches is recommended if the concrete will receive occasional heavy loads, such as motor homes or garbage trucks. To prepare the base, cut the ground level to the proper depth to allow for the slab thickness.
How many 80lb bags of concrete make a yard?
One 80lbs bag of Quikrete Concrete Mix will yield approximately . 60 cu ft. So it will take 45 bag to equal one cubic yard of concrete.
Is it cheaper to build on a slab or piers?
Concrete slabs can be constructed very easily and are cheaper than pier and beam foundations. However, you should know that repairing and maintaining a concrete slab can be more expensive in the long run than taking care of a pier and beam foundation.
How many sq ft does a yard of concrete cover?
How much concrete is in a yard? Concrete volume is measured in cubic yards. When poured on a perfectly level surface, one cubic yard will cover 27 square feet at one foot thick.
Why is concrete so expensive?
As more areas become industrialized—and as there grows a greater need for durable building materials to withstand severe weather and long-term wear—the demand for concrete has significantly increased. This alone has affected the price of concrete over the years.
