QA

How Much Does It Cost For Concrete Driveway

A concrete driveway costs from $8 to $18 per square foot, depending on decorative colors and finishes. While a plain gray concrete driveway costs between $5 and $7 per square foot to install. Concrete is ideal for getting the look of stone or pavers, without the high cost.

Is it cheaper to asphalt or concrete a driveway?

The cost of an asphalt driveway is typically cheaper than concrete, costing $2.00 – $4.00 per square foot. Asphalt prices tend to fluctuate with fluctuations in crude oil prices. In contrast, a concrete driveway costs between $4.00 – $6.00 per square foot for a standard installation.

How much will my concrete driveway cost?

Cost to Pour Concrete Driveway A simple concrete driveway ranges between $4 and $7 per square foot. That includes about $3 to $4 per square foot of materials and $2 to $3 per square foot of labor. A strong mix with 5,000 or more pounds per inch strength leaves you at the high end of that range.

How much does it cost to pour a 24×24 slab of concrete?

A typical 24×24 garage slab costs between $3,057 and $5,944 with prices ranging from $5.31 to $8.31 per square foot for a 4” reinforced slab of concrete, and $6.83 to $10.32 per square foot for a 6” slab of reinforced concrete.

How many yards of concrete do I need for a 24×24 slab?

For example, for a concrete slab that is 24′ X 24′ X 4”, simply enter 4 in the Thickness/Depth field, 24 in the Width field, and 24 in the Length field. Click “Calculate”. Your answer should be 7.11 yards. Note: The Concrete Volume Calculator can also be used to determine yardage for aggregate products.

What is the cheapest way to do a driveway?

Gravel and Stone Driveways A gravel driveway is by far the cheapest and quickest to install, especially if the existing driveway sub-base is sound.

How wide should a driveway be?

How Wide Are Residential Driveways? Primarily, most professionals recommend that you install a 10 feet to 12 feet wide driveway. The standard driveway width for an SUV or conventional pickup truck is 10 feet. Anything less than 10′ wide will likely present difficulties for drivers, even in smaller vehicles.

How do you calculate concrete for a driveway?

Multiply the square footage by the depth in feet to find the volume in cubic feet. You can find volume by measuring length × width × depth. Finally, divide the cubic footage by 27 to find the volume in cubic yards. This is the amount of concrete needed.

How thick should a concrete driveway be?

As for thickness, non-reinforced pavement four inches thick is standard for passenger car driveways. For heavier vehicles, a thickness of five inches is recommended. To eliminate standing water, the driveway should be sloped towards the street a minimum of one percent, or 1/8 inch per foot, for proper drainage.

How much would it cost to pour a 30×40 concrete slab?

How much does a 30×40 concrete slab cost? The average cost is $4 to $8 per square foot. The median price is about $6 per square foot. Based on these averages, you may pay $4,800 to $9,600 with a median estimate of $7,200.

Why is concrete so expensive?

As more areas become industrialized—and as there grows a greater need for durable building materials to withstand severe weather and long-term wear—the demand for concrete has significantly increased. This alone has affected the price of concrete over the years.

How much does it cost to pour a 20×20 concrete slab?

But how much does a 20×20 concrete slab cost? You can expect to pay between $1,600 and $3,200 for a 20×20 slab. The estimates are based on the average cost of $4 to $8 per square foot for a concrete slab. Yet, the costs may vary.

How many yards of concrete do I need for a 10×10 slab?

The amount you will need for a 10 x 10 slab is 1.3 cubic yards, we always add an extra 10% to allow for any slab depth variations or spills that may occur.

How thick should a concrete slab be?

Standard concrete floor slab thickness in residential construction is 4 inches. Five to six inches is recommended if the concrete will receive occasional heavy loads, such as motor homes or garbage trucks. To prepare the base, cut the ground level to the proper depth to allow for the slab thickness.

How much does a yard of concrete cover at 4 inches?

One Cubic Yard of Concrete: 4-inches thick – covers 81 square feet.

How can I save money on my driveway?

But there are low-cost options to consider when planning a new or replacement driveway. One of the best ways to save money is to use loose materials such as gravel, stone, or tar-and-chip (macadam) for your driveway surface.

What type of driveway is best?

Longevity: The longevity of an asphalt driveway is a lot higher than most other driveway options. Homeowners can expect their asphalt driveway to last at least 20 years. Durability: Asphalt driveways are hard wearing and durable. The seal that is applied on top of your asphalt driveway encourages greater longevity.

Do you need planning permission for a driveway?

You will not need planning permission if a new or replacement driveway of any size uses permeable (or porous) surfacing which allows water to drain through, such as gravel, permeable concrete block paving or porous asphalt, or if the rainwater is directed to a lawn or border to drain naturally.