How To Deck Stairs

How do you build stairs on a deck?

How far apart should stringers be on deck stairs?

Deck stairs are typically made from 2 x 12 stringers spaced about 12 to 16 inches apart. They rest on a solid foundation and are attached to the deck with hangers. They have risers (also called toe kicks), treads and railings. The stairs should be at least 36 inches wide.

What should I put on the bottom of my deck stairs?

Your stair stringers will rest on your landing pad, but you should include a base plate. A bearing block is typically a 2×4 that connects your stringers.Footings with Different Deck Stair Landing Options Concrete landing pad. A wood box-type landing pad. Crushed stone. Patio Blocks.

Do deck stairs need toe kicks?

The tread (or depth) of your steps should be ten and a half inches. The risers (or toe kick) must be between seven and eight inches high. A handrail is only required if your deck is more than thirty inches off the ground.

How do you attach stair stringers to a deck?

Attach the stringers to the deck using angle brackets and 3” galvanized deck screws. Cut a 2×6 board to fit snugly between the two stringers at their base. This will be used to fasten the stairs to the concrete pad. Place the board between the stringers and attach to stringers with 3” galvanized deck screws.

Are stair stringers 2×10 or 2×12?

It is acceptable and within building code guidelines to use either 2×10 or 2×12 dimensional lumber to create a set of stairs; however, a stair stringer should not be less than 3.5 inches wide at its narrowest point to provide adequate strength for the load the stairs will be supporting.

What is the code for stair stringers?

Stair stringers should not span more than 13 feet and 3 inches (4039 mm) for a closed stringer. Cut stringers should not span more than 6 feet (1829 mm). Refer to the American Wood Council’s 2018 Prescriptive Residential Wood Deck Construction Guide for stringer spans.

What is code for deck stairs?

Requirements for Deck Stairs Stair rails on decks should be between 34 inches and 38 inches high, measured vertically from the nose of the tread to the top of the rail. Treads must be at least 10 inches deep, measuring from front to back.

Do steps need footings?

Contrary to entry steps, a set of lawn steps do not need footings because they are not attached to anything else with footings (eg. concrete sidewalk). If a set of lawn steps move due to frost heave or otherwise, the consequences do not justify the cost of installing footings.

Can you use joist hangers for stair stringers?

Use joist hangers to fasten the blocking. Pros: Allows for the use of all types of stair stringer hangers. The top of the stair stringer acts as the first tread instead of being flush with the deck’s surface.

Do deck stairs need a footer?

SAFE, SUPPORTED STAIRS: Deck-stair construction varies, but the general requirements are consistent: proper footing support, and an adequate landing. Regardless of the stair run and number of treads, the stairway needs a footing at the bottom to support the stringers—they can’t just rest on the ground.

Can I make stringers out of 2×10?

Pressure-treated or cedar 2×10 or 2×12 can be used depending on the depth of the cut-outs you’ll be using. By code you will need a minimum of 3-1/2″ of material left on the stringer after the cut-outs and that area should also be free of large knots which would weaken the stringer.

What size lumber are stair stringers cut from?

Selecting stringer stock Stringers should always be cut from 2x12s. Notching smaller stock doesn’t leave enough wood to safely carry the loads of a stair. When ordering stringers, allow about 14 inches of stringer length for each step. Look for straight stock with as few knots as possible.

How far can 2×12 stair stringers span?

A 2×12 stringer has a maximum unsupported span of 6 feet. These stairs (7) are likely to deflect and cause the stringers to either pull loose from the framing or shear along the grain.

How far should a stair tread hangover?

The tread nosing must overhang between 3/4” and 1-1/4” unless the tread is 11-inches or greater in depth. The stair lip improves safety by extending the horizontal space available for ascent and descent, and visually defines the step edge.

How thick should a stair stringer be?

According to general specifications, your stair riser thickness should be no less than ½”. In fact, many professionals recommend risers with a thickness of ¾”. It’s also important to note that if you do build a closed riser staircase, your stair treads will need to have a note as well.

Do you need railings on both sides of stairs?

Handrails are required on both sides of stairs and ramps. They are placed between 34 inches and 38 inches above the leading edge of a stair tread, the ramp surface, or the walking surface. Where children are the primary users of a facility, the ADA recommends a second handrail for children.

What is the standard step height for stairs?

Riser Heights In the United States, the step height standard should be between 7 or 7 ¾ inches at the most, and no less than 4 inches. You should follow other measurements if given by local building codes. In Canada, the maximum step riser height is 8 ¼ inches.

Do stair stringers need support?

Yes, the stringers need to be supported along their length, but they can span a few feet too, depending on 1) the width of the stairs, 2) the number of stringers, and 3) size of riser board. 1) The wider the stair the more load will be transferred to the stringers.

What is a floating staircase?

What are Floating Stairs? Floating stairs are a type of straight staircase that is self-supported. Because of the self-supported design a floating staircase requires no extra support between the underside of the staircase and the floor below or a wall.

Do deck stairs have to land on concrete?

Stair landings must be at least as wide as the stair and at least 3 feet deep. On the other hand, solid, flat, and stable materials, such as concrete, flagstone, pavers, or brick, can be installed with a measurable slope and will not usually shift under the weight of an off-balance person completing a stairway descent.