Table of Contents
Is Pergo flooring hard to install?
Pergo floors are more than just beautiful and durable, they’re also easy to install. Even if you’ve never installed a floor before, it’s easy to put new floors in your home in less time with just a few simple tools.
Do you need underlayment for Pergo flooring?
The Pergo flooring must be placed at least a 1⁄4″ beneath the undercut jambs and casings. Pergo planks are installed over Pergo SilentStep™ or Soundbloc™ foam or equivalent foam underlayment when the Pergo product that you are installing does not have an attached underlayment foam.
Where do you start when laying laminate flooring?
Begin the first row of flooring by placing the planks with the tongue side facing the wall. Install the second plank next to the first by aligning the tongue into the groove and press the plank down to snap it in place. When you come to the end of the first row, cut the length of plank needed to complete the row.
Which direction should I lay flooring?
The most common way to lay hardwood flooring is by aligning the planks parallel to the longest wall. Apart from a few exceptions like sagging joists, this is the preferred direction to lay wood floors because it aesthetically provides the best result.
Does Pergo flooring scratch easily?
Pergo claims that the floors are scratch resistant but not scratch proof! We had the floors for roughly 3 years before we moved from our last home and I didn’t notice any scratches and we WERE NOT EASY ON THEM.
Which side is the tongue on Pergo flooring?
Installing laminate flooring. Install the tongue towards the wall you are starting on. The tongue should be removed from the long side of all of the planks in the first row and from the short end on only the first plank.
What is the tongue on Pergo?
Each laminate flooring plank contains a tongue and groove, these edges of the board cause your locking system to click together. The tongue on laminate flooring is the small flat edge on one side of the board, this is the top edge that is going to angle and lock into the bottom side of another board.
What happens if you dont use underlayment?
If the subfloor in your home or property is uneven, then your laminate floor could move and shift if it doesn’t have an underlayment for support. As a result, the floor will be more prone to wear-and-tear and could even warp. The more stability, the less likely you’ll have to pay out of pocket for costly repairs.
Can you use felt paper under laminate flooring?
Floating floors can be installed over any existing hard floor surface, but should have an underlayment between the laminate flooring and the subfloor. You can buy laminate underlayment, but if you have a bunch of old roofing felt, it works just as well.
Do I need a vapor barrier for Pergo outlast?
When Pergo Outlast+ flooring is installed over vinyl, linoleum sheet goods, over resilient tiles or ceramic tiles and the subfloor is concrete, a vapor barrier is always required.
Does it matter which direction you lay laminate flooring?
In what direction should you lay a laminate floor? In most cases, you should lay your laminate flooring parallel to the longest side of the room or your home. This will create a more natural flow and will accentuate the length of the room better.
Do you have to cut the tongue of the first row of laminate?
Place the first plank with the tongue side towards the wall, being sure to allow 1/8″ for expansion. We recommend cutting off the tongue on this first row to avoid any problem with the expansion gap. If it is too short, cut a new plank in half and use one half to start the second row.
Does the tongue or groove go against the wall?
Which to Install First. Which side is the tongue, which the groove, and which goes first during installation? The tongue is the side that you will want to place against the wall as you start your laminate-flooring installation.
What happens if you don’t stagger laminate flooring?
The main problem with laminate flooring that has not been properly staggered is that it is more likely to separate from the boards it is adjoined to. In addition, in severe circumstances, the boards may lift or move out of place.
When laying laminate flooring do you stagger?
Laminate flooring should be staggered by 6 inches or more. If the seams are too close together, then the floor cannot “breathe” properly, and the seams can break down. To prevent this, cut the first board in a row to a length that staggers the seams by 6 inches or more.
Can you lay normal laminate in herringbone pattern?
It is possible to install laminate flooring in a herringbone pattern, provided you purchase the correct type of flooring. Most manufacturers and suppliers offer a range of herringbone laminate floors that come in a vast array of shades, patterns, styles, and colors to suit your style and decor.
Should wood flooring be laid in the same direction throughout the house?
Wood floors should always be laid perpendicular to floor joists—across rather that in between them. This will make the floors structurally sound and will help prevent the planks from separating, sagging or buckling. So, there is no right or wrong way to lay your wood flooring.
Should floors be darker or lighter than walls?
Many home experts agree that the floor color should be darker than the walls. The rule generally applies because lighter walls and a dark floor make the room seem larger. Most homeowners prefer a spacious looking interior. However, the rule can change with low ceilings.
Should flooring be same throughout house?
There is absolutely no need to change flooring from room to room. We often work with homeowners who feel the urge to pick a different flooring for every room of their home, but there is absolutely no need to do this. Your home will look best if you create one consistent look that travels from room to room.
