QA

Quick Answer: How To Move A Toilet Location

Instructions Remove the Toilet. Remove the toilet from its current location. Gain Access. Remove the Toilet Flange. Cut the Toilet Bend. Position the New Drain Location. Run the New Drain. Install the Drain Stub-Out. Run the Water Supply Lines.

How much does it cost to move the location of a toilet?

The cost to move a toilet or sinks can be $2,500-$3,500 per fixture. Plumbing can be a significant cost factor in a remodel when a bathroom floor plan is altered. The toilet is the most expensive to move.

How far can you move a toilet from the stack?

If your waste line has a diameter of 3 inches, you can place the toilet within six feet of your stack. The toilet can also be as far as 10 feet from your stack, if the diameter of the waste line is 4 inches.

Can a toilet waste pipe be moved?

There is usually a vertical waste water pipe under the toilet that uses gravity to move wastewater away. For the waste water line, an offset toilet flange will allow you to move the toilet a couple of inches in any direction without having to cut a new hole in the floor or reconstruct the waste water pipe.

Is it possible to move a toilet in a bathroom?

Moving a toilet is not a straightforward weekend DIY job, but it is very doable when you involve the professionals. Once the toilet itself is removed, your plumber will have to move the drainage, as well as the water supply to accommodate the new location.

Can you swap a toilet and sink?

You can potentially rearrange fixtures and still make use of the existing plumbing. For instance, you can have your toilet and your sink swap places. You have cold water running to the existing toilet area, which fills the tank in the back.

How do you transport a toilet?

How to Move a Toilet in 8 Simple Steps Make a plan. Make space for the toilet before you move it. Turn off the water. Remove remaining water. Disconnect the supply line from the toilet. Remove the bolts. Remove and move the tank. Remove and move the toilet bowl. Clean and plug the drain hole.

Can you put a toilet anywhere in your house?

On a serious note, it is absolutely possible to install a toilet, even a bathroom as a matter of fact, anywhere in your house. In the past, many homeowners have had the idea of their dream bathroom crushed because the location was simply too far away from the main drain.

Is it expensive to move a toilet UK?

Plumbing Relocation Cost Moving plumbing fixtures for a bathroom will likely cost you between £700 and £900. This may involve rerouting plumbing pipes to adapt for a new bath, sink, or toilet.

How far can a toilet be from the soil pipe?

The furthest the toilet would be away from the pipe is 2metres due to the size of the bathroom. I’d also have to keep all pipe work above the concrete floor and accessible in some way in case future plumbing work is needed.

Can you move a toilet to an inside wall?

Generally, you can install a toilet on an internal wall as long as there is enough room underneath the floor to run the waste line to the mainline. If there is enough room, the only other requirement is that you have a wall with the proper structural studs in it and cavity space for the piping.

How far is toilet from wall?

Most codes require at least 15 inches (measured from the center of the toilet) from any side wall or obstruction and not closer than 30 inches center to center to any other sanitary fixture. (The NKBA actually recommends 32 inches.) There should be at least 24 inches of clear space in front of a toilet or bidet.

How hard is it to move plumbing in bathroom?

Relocating plumbing can be a time consuming and hard work. That’s why you should only do it if you have prepared beforehand and if you have confidence in the professionals you chose to do the job. But take comfort in the fact that once it’s done, you won’t have to think about it for a long time.

How do I rearrange my bathroom?

That being said, here are 6 simple suggestions to improve your bathroom layout, without the hassle and the expense of moving your plumbing. Replace the existing bathroom door. Resize your vanity. Float your fixtures. Divide the space. Switch the tub for a shower. Keep the tub AND add a luxurious accessible shower.

Does the toilet have to be next to the shower?

A minimum clearance in front of the toilet of at least 21 inches. This is required for all your bathroom fixtures, including the shower, vanity or sink and bathtub. A minimum distance from the center of the toilet to both side walls of 15 inches.

How hard is it to move a toilet location?

Moving a toilet is not so much about moving the actual fixture—in fact, installing a toilet is a simple job that takes less than an hour—as it is about moving the drainage and the water supply plumbing to the new location. Once all of the plumbing is in place, installing the toilet is a relatively easy task.

How do you remove a toilet from a new floor?

Remove the toilet by gently rocking the bowl back and forth until it loosens from the wax ring it sits on. Firmly grasp the toilet bowl, lift up and remove it. (Lifting by the tank can cause damage or separation from the bowl.) Gently set the toilet to the side.