Table of Contents
How do you remove old paper from a steamer trunk?
Use a hair dryer to blow warm air into the trunk, directing it at the face of the slats. It might take up to 30 minutes, but make sure the water or moisture is gone from the trunk. After it’s dry, sand individual slats with 100-grit sandpaper to smooth and remove splinters or chips.
How do you remove wallpaper from the trunk?
For Stripping and Staining: Use a damp cloth to get the old paper damp, and let it stay that way for a couple of hours. Then use a paint scraper to remove the wall paper. Get what you can, sandpaper will get the rest. Choose your favorite stain, then finish the wood.
How do you clean an old trunk?
Clean metal antique trunks with a mixture of one part white vinegar and one part water in a spray bottle. Gently clean paper lined trunk interiors by spraying the vinegar solution on your cleaning cloth and carefully wiping down the interior.
How do you get paint off an old trunk?
Apply a coat of paint stripper to the outside surface of the trunk. Allow the paint stripper to sit on the trunk for approximately 10 to 20 minutes. Read the manufacturer’s instructions for wait time for your particular kind of stripper. Scrape the paint or finish from the surface with a putty knife.
How do you line a trunk with wallpaper?
Measure the area where you want to apply the first piece of wallpaper and cut to length. Using the foam brush, paint the mod podge on the back of the wallpaper. Carefully place the wallpaper where you want it to go, making sure the ends are lined up with the edges of the trunk.
How much is an old trunk worth?
The average American made antique trunk is worth about $100 to $300 depending on the style, size and condition. If fully restored prices can be anywhere from $400 to $1300.
How do you refurbish an old metal trunk?
Rub the rust in a circular motion with steel wool, remembering that steel and tin, which are harder, may require a wire brush, while brass, which is softer, might be quickly restored with steel wool. Still, a heavy buildup of rust on brass might require the wire brush.
How do you reuse an old trunk?
A vintage trunk can be also turned into a home bar, just renovate or decorate it as you need and then put on some legs of your choice, or put several trunks on each other. Voila! you can use the top or open the chest and place bottles and glasses inside.
Are steamer trunks valuable?
These are the two most important factors in determining the value of your antique steamer trunk. Louis Vuitton trunks will sell for between $3000 and $20,000 while an unmarked steamer trunk will only sell for between $75 and $100. Martin Maier and Goyard steamer trunks may sell for between $500 and $3000.
How do you refurbish an old chest?
How to Refinish a Wood Chest 1 Clean the Chest Up. Place the chest on a work surface at about waist height. 2 Remove the Hardware. Use a screwdriver to remove hinges and latches. 3 Repair Cracks + Splinters. 4 Fill Dents + Scratches. 5 Sand the Chest. 6 Nooks + Crannies. 7 Final Sanding. 8 Wipe On, Wipe Off.
What is a camelback trunk?
This trunk was commonly called a camel back, dome top or steamer trunk. The top on this trunk curves both directions. This design was first made in the early 1800’s in Europe. The top was designed to prevent other luggage from being stacked atop them when used in traveling by ship to America.
How are rivets usually removed?
The only way to remove rivets is to essentially destroy them. You do this is by “drilling out” the rivet. You use friction from a drill bit to cut away at the inner wall of the fastener. That way, you separate the shaft from the head.
How do you remove a rivet without a drill?
For smaller rivets, use a drill bit to drive through the surface. For stubborn rivets that you can’t drill through, grind off the head of the rivet, then bore through it. You could also use a hammer and chisel to break off the head of the rivet and drive it through the surface if you don’t have a drill.
How do you get paint off of a metal chest?
How to Remove Paint from Metal STEP 1: Prep the area and protect yourself. Prepare the work area by covering the ground with drop cloths. STEP 2: Apply paint stripper. Pour a small amount of the stripper into a glass or metal can. STEP 3: Scrape the paint. STEP 4: Apply mineral spirits. STEP 5: Clean the metal.
What material is trunk liner?
Trunkliner Fabric is made from Ecofi nonwoven, solution-dyed synthetic fibers. This extremely durable fabric has excellent colorfastness, UV resistance, as well as a high resistance to mold, mildew and stains—even gas, oil, and salt! Easy to work with, Trunkliner cuts with scissors without fraying.
How do you line an old trunk with cedar?
How to Cedar Line a Trunk Start with the bottom. Glue the boards to the bottom of the trunk and let dry. Cut the pieces for the two ends of the trunk. Glue the end pieces into place. Measure and cut the boards to go on the two longer sides. Glue these side pieces and let the glue dry.
