QA

Quick Answer: Where To Drain Furnace Condensate

Most furnaces will have at least 2 internal drains, typically one for the heat exchanger and one for the vent, usually at the inducer outlet or on the inducer housing.

Can furnace condensate drain outside?

A furnace produces condensate as it works (it’s part of the combustion process), and this condensate must be drained and removed to the outside. If the pipe that runs the condensate to the outside of the house freezes over, your furnace won’t be able to work!.

Where can I drain my condensate line?

You’ll find a white PVC or copper pipe located near your outdoor unit—this is where the drain line ends. Near your indoor unit, you’ll find a vertical PVC pipe with a cap on it, which acts as the access point for the condensate drain.

Where Should 90% furnaces drain to?

Most “90%” furnaces will have at least 2 internal drains, one for the heat exchanger and one for the vent. One will be located at the inducer outlet or on the inducer housing. The secondary heat exchanger outlet is sealed inside a plastic part called the collector box.

How do I get rid of condensation in my furnace?

Many times the clogged drain can be cleared with wet/dry vacuum suction. You can also try removing the clog with a plumber’s snake. Use the access port to flush the drain with white vinegar, diluted hydrogen peroxide, or hot water and a drop of dish soap.

Do furnaces drain water?

A conventional furnace, also known as a standard efficiency furnace, does not produce water. However, if you have a high efficiency furnace, (90 % efficiency), condensation will arise due to the addition of the second heat exchanger. From there, the condensation is drained into a condensate pump or a floor drain.

How much water does a furnace drain?

A 90% or higher efficiency furnace produces around 0.8 gallons of condensate per hour of running. This equates to about five or six gallons per day of acidic water from condensation each day. Most of the time, the drain and drain line runs to outside the home and the condensate just seeps into the ground, harmlessly.

Can the furnace drain and the air conditioning drain be run with a common drain?

In general, you should not run the air conditioning condensate drain and the furnace condensate drain into a common line. The positive pressure from the coil can travel through the drain to the furnace drain and cause the vent safety switch to trip. The drain should slope away from the furnace until its outlet.

Should condensate trap be full of water?

The boiler should never be operated without the condensate trap in place, as it prevents noxious combustion gases from travelling down the condensate pipe. Should the trap have to be removed from the boiler, it must be topped up with water when it’s replaced.

Does a condensate drain need a trap?

The only code requirements for drain lines removing condensate from HVAC equipment are: a) for the installation of a trap in accordance with the unit manufacturer’s installation and operating instructions; b) that the drain lines slope toward the final drainage point at a rate of 1/8 inch per foot.

Do high efficiency furnaces need a drain?

A high-efficiency furnace (also called a condensing furnace) will always have condensation as a byproduct of heating your home. A floor drain is necessary for your high-efficiency furnace because the water has to go somewhere and a floor drain is the easiest and most effective outlet.

Does a furnace drain need a trap?

The furnace drain in a high-efficiency furnace needs a trap to prevent a potential exhaust gas leak into the living space. The trap also keeps the inducer motor from sucking air through the drain. The position of the drain trap depends on the type of air handler you have installed.

What is a condensate drain?

A condensate drain line is a line that runs through a home or building’s central air conditioning system and leads to the outside. Condensate lines are typically crafted with PVC pipe or metal, and they provide a funnel for the humidity and condensation created by air conditioner evaporator coils as the systems run.

Why is there water around my furnace?

The most common reason for water under your furnace is a clogged condensation drain. If the drain system from the unit gets a clog in it, that water will spill out onto the floor. Condensation from air conditioning coils contains bacteria that can form slime and clog the condensate pan drain tube.

Can water damage a furnace?

Water that comes from HVAC leaks and flooding can cause serious damage to your system. It can get into your pipes, ductwork, furnace or air conditioner. Unchecked water can short your electrical components or can cause harmful corrosion.

Why does a furnace need a condensate pump?

Condensate pumps are used to effectively direct and remove excess water from high efficiency furnaces (as well as humidifiers and A/C units). The pump takes the place of hoses that can and do rupture, and seamlessly transfers water to the appropriate drainage pipe.