Table of Contents
Each bracket should be placed at the height you previously determined and about four to six inches from the side of the window frame. (This will allow you to open the curtains completely.) Check to make sure your pencil marks are level otherwise the entire window treatment will be crooked.
How high should a curtain rod be?
The higher the curtain rod, the taller the window will appear, so fix your curtain rod closer to the ceiling than the top of your window, if you can. One rule of thumb is that they should sit 4-6 inches above the window frame.
How far should a curtain rod be from the wall?
General Installation Recommendations. When installing curtain rods, hang the rod so that it extends at least 3 or 4 inches beyond the window on each side. This allows your curtains to overlap both the window and the wall to prevent light from leaking in around the window’s edges.
How far should curtain rod be from side of window?
The standard distance from the window casing to the end of the curtain rod (excluding finials) on each side of the window should be four to 10 inches. As a general rule, drapes will be open during the day, so make sure the curtain rod extends at least four inches on each side of the window’s inside frame.
How far should a curtain hang from the floor?
The proper position is ½ inch above the floor for free hanging curtains. This distance allows for mopping and cleaning while creating the illusion that the curtain touches the floor.
How many brackets do I need for curtain rod?
Count how many brackets are included with the curtain rod. As a general rule, there should be at least one bracket for each outside corner of the window, and one bracket in the center. Add more brackets if the expanse between the middle and outer brackets is more than three feet.
How far out do curtain rods extend?
Curtain rods should extend at least 3 to 6 inches past the window frame. Just as hanging curtains above the window frame makes the window appear taller, Bob Vila writes that extending the curtain rod past the window frame makes the window appear wider.
Is it OK for curtains to drag on the floor?
Curtains that drag on the floor can be a hazard and collect dust more easily. Aim for a middle ground—curtains that hover just above the floor. How to fix it: To find the right curtain length, measure from the floor to where you’ll hang the rod. Curtain lengths come in common lengths like 63, 84, and 96 inches.
How high should you hang curtains with 9 foot ceilings?
In Closing. For a 9-foot ceiling, 96-inch curtain panels are typically a good fit. This allows you to hang curtains that reach the floor, with the rod placed one foot from the ceiling. If you prefer curtains that pool on the floor or curtains that hang higher, just pick the next size up.
Should curtains touch the floor or window sill?
In formal or dressy rooms, curtains should just touch the floor. A romantic room deserves elegant, extra-long curtains that pool or puddle on the floor. Curtains to the sill, or to the bottom of the window trim (called the apron), look great and are practical in a kitchen.
How much longer should curtains be than the window?
A common rule for displaying curtains properly says the curtains finished width should be at least 2 times the width of your window (if not more – sheers can be 3 times the window width) to achieve a look of proper fullness.
How high should a curtain rod be for 84 inch curtains?
The length of the curtain dictates the height of the rod. If you buy 84-inch-long curtains, the rod must be mounted roughly 84 inches from the floor if the curtains hang from the rod without rings. This lets the hem of the curtains brush the floor.
Do you need middle bracket on curtain rod?
A center bracket is needed in almost any length greater than 5 to 6 feet, if you want to avoid any sagging. However there are “C” rings that will go over the bracket so that the drapes/curtains can be pulled to one side (either side, in fact).
What is bracket projection?
Projection is the measurement of the full extension of the curtain rod bracket, front to back, from the mounting plate to the outer point/end. It is measured from the front of the bracket back to the wall. This is the overall extension of the bracket, front to back.
Which side of curtains should be inside on door?
But the fabric side (also described as the woven or rough side) is made to face the window because of the durability. Face the fabric side out to avoid yellowing or sun damage, which will preserve the lifespan of your curtains.
How do you support the middle of a curtain rod?
If the curtain rod stands too far from the window for the pipe rail tie to work, you can make a support from a long, heavy-duty screw hook. Screw hooks are similar to eye hooks, which are heavy screws with a loop or ring at the end. Instead of a loop, screw hooks are shaped like a U or a C.
How do I keep my curtain rod from sagging in the middle?
10 Clever Ways to Fix a Sagging Curtain Rod at Home Realign the Support Brackets. Provide Extra Support Brackets. Insert Another Support Rod. Change Your Fabric Material. Reduce the Cotton’s Length. Use a Barrier to Protect Your Curtain. Get a More Durable Curtain Rod. Replace Your Support Brackets.
