QA

Quick Answer: How Deep To Sink A Fence Post

Dig post hole so diameter of the hole is 3 times the width of the post (i.e., the hole for a 4” wood post should be about 12 inches wide). The depth of the hole should be 1/3-1/2 the post height above ground (i.e., a 6-foot tall fence would require a hole depth of at least 2 feet).

How deep should an 8 foot post be in the ground?

In general, holes should be at least 3 feet deep for posts that extend 8 feet or more above ground level. Posts that extend 6 feet above ground level should have holes at least 2 1/2 feet deep.

Is 2 feet deep enough for fence posts?

2 feet is the minimum depth that you should dig your fence post holes for. To dig the holes one-third to one-half of the post’s aboveground height, is a general formula. The deeper you dig the holes, the more stability your fence has.

Should fence posts be set in concrete?

Do Fence Posts Need To Be Set in Concrete? No, fence posts don’t need to be set in concrete, and there are plenty of other ways to fix your posts if this feels a bit too permanent. If you are using wooden posts, concrete may actually be the worst option.

How deep should a concrete fence post be?

Dig your hole to the correct depth, allowing for the height of the fence panel and the gravel board. As a rough guide the hole should be a minimum 1/3 the height of the fence, so a 6 foot fence would need an 8 foot post in a 2 foot deep hole. Similarly, the hole should be three times the diameter of the post.

Is 18 inches deep enough for a fence post?

The general rule of thumb when setting a post is that the depth of the post’s hole needs to be one-third to one-half of the actual above-ground height of the post. So, a six-foot-high finished post ideally needs to be buried three feet into the ground.

How tall should a fence be for a 6-foot fence?

As a general rule of thumb, you’ll need to place at least 1/3 the height of the post in the ground. For example, a 6-foot tall fence will need at least 2 feet of post in the ground.

How shallow can a fence post be?

For any type of fence, the depth of the hole you must dig depends on how tall the post will be above ground. You should always bury one-third of your fence post underground. For a 6-foot fence, for example, you need a 9-foot post, so that 3 feet can be underground.

How many bags of concrete do you need for a fence post?

1 – 4 bags of concrete per fence post are typically what’s needed. This depends on the type of soil, fence design, height, post size and bag weight. In general the depth of the post’s hole needs to be 1/3 to 1/2 of the above ground height of the post.

How long will a treated 4×4 post last in the ground?

How Long Will A Treated 4×4 Last In The Ground? (Explained) A treated 4×4 will last 20 to 25 years in the ground if the conditions in the soil and climate are favorable. That number could increase to 40 to 75 years if you install the treated 4×4 in a cement ring rather than the soil.

Can you reuse fence posts with concrete?

Pulling up an existing fence post to reuse can be quite a task. Posts with concrete at the base are the most difficult to remove and reuse because the concrete base is larger than the post, which makes pulling it up through the ground much harder.

Should a fence post wiggle?

WOBBLY wooden fence posts should be repaired promptly before they cause other fence parts to loosen. Posts that have been in the ground for less than five years usually wobble because of improper installation; ordinarily, tightening them is fairly easy.

How heavy is a 8 ft concrete post?

approximately 44kgs Type Concrete Slotted Intermediate Fence Post Length 2440mm (8ft) Weight 44 kg.

What size fence post do I need for a 5ft fence?

Use 4in x 4in posts for fences of 5ft and over and 3in x 3in posts for anything under 5ft.

What thickness should fence posts be?

There is a choice of post sizes available. 75mm x 75mm may be adequate for lower fences but for higher fences or exposed positions we would recommend 100mm x 100mm.

Will wooden posts rot in concrete?

Simply setting the posts in concrete does create a condition that will accelerate rot in the bottom of the posts. With pressure-treated posts, the rot will be slow. This allows any moisture that gets between the concrete and the bottom of the post to percolate through the gravel and away from the bottom of the post.

How deep should timber fence posts be?

Rule of Thumb Hole depth = put approximately 1/3 of the post in the hole. A 2m (6 foot) post should have up to 600mm (2 foot) in the ground.

Can you put dry concrete in a post hole?

Fast-setting concrete is ideal for setting posts because there’s no mixing—you simply pour the dry concrete from the bag right into the hole, then add water.

What size post do you use for an 8 foot fence?

A common rule of thumb, is to dig the hole 3 times as large as the post, and to a depth of 1/3-1/2 of the post height above ground. so for a 8′ high fence, using 4×4 posts. dig the holes 12″ in diameter, to a depth of 2 1/2 – 4′. Of course, that’s assuming you’re setting the posts in concrete.

How big of a hole do you need for a 4×4 post?

The diameter of your post hole should be three times the diameter of your post. So, if you’re planning on using a four-inch round or 4×4-inch square post, your post hole will need to be 12 inches in diameter. For a six-foot-high fence post, we would need a hole that’s 36 inches deep and 12 inches in diameter.