Table of Contents
Install the Offset Flange Positions the offset flange so that the bent end moves the flange opening closer to the wall. Make sure the back of the offset flange connects snugly with the drainage pipe. Check to make sure that the flange’s opening is sitting flush and even against the bathroom floor.
Is it difficult to relocate a toilet?
Moving a toilet is not so much about moving the actual fixture—in fact, installing a toilet is a simple job that takes less than an hour—as it is about moving the drainage and the water supply plumbing to the new location. Once all of the plumbing is in place, installing the toilet is a relatively easy task.
How do you move a toilet from the wall to further?
To move the toilet more than just a couple of inches, you will have to demolish the concrete to access and relocate water and waste lines. Then you will have to rebuild the concrete foundation and replace the sub-flooring, flooring, and fixtures.
Can a toilet be moved a few inches?
Yes, you can actually move a toilet. Even moving a toilet by a few inches without having to make a new hole in the floor is possible. You can use an offset toilet flange to move the toilet by a couple of inches on any side. This will allow you to use the same wastewater line and in turn help to save you a lot of money.
How close to the wall should a toilet be?
Most codes require at least 15 inches (measured from the center of the toilet) from any side wall or obstruction and not closer than 30 inches center to center to any other sanitary fixture. (The NKBA actually recommends 32 inches.).
How do you relocate a toilet?
How to Move a Toilet in 8 Simple Steps Make a plan. Make space for the toilet before you move it. Turn off the water. Remove remaining water. Disconnect the supply line from the toilet. Remove the bolts. Remove and move the tank. Remove and move the toilet bowl. Clean and plug the drain hole.
Do all toilets sit the same distance from the wall?
The plumber determines the actual distance when he sets the toilet flange in the floor. The standard distance from the back wall is 12 inches, or 12-1/2 inches from the center of the flange to the wall framing. Minimum distance in front of the toilet to the facing wall or fixture is 21 inches.
How do you fill the gap between toilet cistern and wall?
If there is no way to move the pan back, then cut a couple of bits of white 32mm waste pipe to fit between the cistern and wall, one for each screw hole, and then screw the cistern back with longer screws. 25mm isn’t too bad and once the lid is on will look fine.
Does a toilet have to be against a wall?
Toilets should have a minimum of 15 inches from walls that flank the fixture. A distance of 12 to 12.5 inches should be between the center of the toilet flange and the back wall.
How much does it cost to relocate a toilet?
The cost to move a toilet or sinks can be $2,500-$3,500 per fixture. Plumbing can be a significant cost factor in a remodel when a bathroom floor plan is altered. The toilet is the most expensive to move. Connecting the toilet to the existing sewer line can be a bit tricky for your plumber.
Can you put a toilet anywhere in your house?
On a serious note, it is absolutely possible to install a toilet, even a bathroom as a matter of fact, anywhere in your house. In the past, many homeowners have had the idea of their dream bathroom crushed because the location was simply too far away from the main drain.
How far away from the wall is a toilet flange?
The Distance To Set The Toilet Flange From The Back Wall. You’ll want to set the center of the water closet flange 12 inches from the finished back wall.
Can you move a toilet to an inside wall?
Generally, you can install a toilet on an internal wall as long as there is enough room underneath the floor to run the waste line to the mainline. If there is enough room, the only other requirement is that you have a wall with the proper structural studs in it and cavity space for the piping.
How far can a toilet be from the main stack?
Tie the waste line from the new toilet directly into the stack if the toilet is within six feet of the stack and the waste line is 3 inches in diameter. If the waste line is 4 inches in diameter, the toilet can be as far as 10 feet from the stack.
Can you switch a toilet and sink?
Ultimately, you can move your sink, tub, and toilet in a bathroom renovation, but doing so will require a reworking of your plumbing and electrical systems, and that will be an added cost to the project. That cost comes on top of the expenses of demolition, installing flooring, putting up drywall, and so on.
How far away should the toilet be from the vanity?
Toilet placement A toilet should have some elbow room between it and another fixture or vanity. The NKBA’s recommendation is at least 18″. Codes allow a minimum distance of 15″.
Is it expensive to move a toilet UK?
Plumbing Relocation Cost Moving plumbing fixtures for a bathroom will likely cost you between £700 and £900. This may involve rerouting plumbing pipes to adapt for a new bath, sink, or toilet.
